Lem electrical components Germany Lem model Lem price

Lem electrical components are energy conversion devices that convert sound signals into electrical signals. Categories include moving-coil, condenser, electret, and the recently emerging silicon microphones; in addition, there are liquid microphones and laser microphones. Most microphones are electret condenser microphones, which operate using a polymer diaphragm with permanently isolated charge.

Lem electrical components classification

Circuit breakers are classified by number of poles: single-pole, two-pole, three-pole, and four-pole, etc.; by mounting method: plug-in, fixed, and draw-out, etc.

Lem electrical components function

Low-power resistors are typically composed of carbon film encapsulated in a plastic housing, while high-power resistors are typically wirewound resistors, made by winding metal wire with high resistivity around a ceramic core. If a resistor's resistance value is close to zero ohms (for example, a large-cross-section conductor between two points), the resistor offers no obstruction to current, the circuit paralleling such a resistor is short-circuited, and the current is infinitely large. If a resistor has infinite or very high resistance, the circuit series-connected with this resistor can be regarded as an open circuit, and the current is zero. Resistors commonly used in industry lie between these two extremes; they have a certain resistance and can pass a certain current, but the current is not as large as in a short circuit. The current-limiting function of a resistor is similar to the effect of a small-diameter pipe connected between two large-diameter pipes restricting water flow. Resistance, usually abbreviated as R, is a fundamental property of a conductor, related to the conductor's dimensions, material, and temperature. Ohm's law states that I=U/R, so R=U/I. The basic unit of resistance is the ohm, denoted by the Greek letter "Ω", defined as follows: the resistance corresponding to a current of one ampere generated when one volt is applied across a conductor. The main function of a resistor is to impede the flow of current. In fact, "resistance" refers to a property, while "resistor" in electronic products usually refers to the component itself. Ohm is often abbreviated as ohm. Common units for expressing resistance values also include kiloohm (kΩ), megaohm (MΩ), and milliohm (m Ω).

Lem electrical components parameters

Key technical parameters of solid-state relays include: input voltage range, input current, turn-on voltage, turn-off voltage, reverse polarity voltage, rated output current, rated output voltage, output voltage, output leakage current, turn-on time, turn-off time, zero-crossing voltage, maximum surge voltage, electrical system peak, voltage rate of rise, operating temperature, ambient temperature range, dielectric withstand voltage, insulation resistance, electrical system peak, turn-off time, conduction time, output terminal leakage current, maximum on-state voltage transient overvoltage, maximum zero-crossing turn-on voltage, power consumption, maximum surge current, minimum load current, maximum load current, output voltage range, minimum input impedance, reverse polarity voltage, input current, guaranteed turn-off voltage, guaranteed turn-on voltage, input voltage range.

Weidou Intelligent Technology specializes in selling German Lem connectors, Lem switches, Lem relays, Lem controllers, Lem plugs, Lem sensors, Lem resistors, Lem capacitors, Lem bus, Lem modules, Lem cables, Lem power supplies, Lem interfaces, Lem gateways, Lem circuit breakers, Lem original imports from Germany. Welcome customers to inquire and order.